I recently installed Discourse again, but in Hetzner servers. Now I have 4GB of RAM and 40GB of space. By default it created the 2GB swap file [image] Is that enough?

Watch it using htop during a build. Probably enough.

Which Linux distro did you use for the install on the servers? I would have recommended using a swapfile instead of a swap partition. Swapfiles are the default nowadays on most distros and are more flexible in terms of adjusting the swappiness.

I don’t believe a swap partition was mentioned? [image] alltiagocom: it created the 2GB swap file I think 2GB swap + 4GB RAM is enough. I don’t think you’d need more swap unless you’re running other stuff on your server as well.

My apologies, you are correct. Should have made sure to drink more coffee before replying :wink:

It depends how much there in plugins in use, AI etc. For me 4+2 wasn’t enough.

I’m not an expert so I just took some screenshot along the way: [SCR-20251221-ilhi] [SCR-20251221-imkv] This was right after it completed: [SCR-20251221-imvf] Then, I let it run for a little bit longer, because I was seeing the 0 and 1 bars (I’ assuming those are the cores?) both hitting around 80% and I wanted to see if that was just temporary: [SCR-20251221-ince] [SCR-20251221-infh] [SCR-20251221-inoo] [SCR-20251221-inzv] Does this help? For the most part, the Mem was no higher than maybe 500M, average. During the rebuild the highest it went was maybe 1GB or so, but very briefly. Only after the rebuild stopped did it go to those values of 1.6GB or so. And even now, after it stopped for a few minutes, I’m still seeing this, so I wonder if that’s normal? [image]

@NateDhaliwal and @Rubi I didn’t do anything myself, it created it automatically, so I’m assuming it’s swapfile? I just followed the official instructions to install and let it do its thing. Hope that clarifies? @Jagster I don’t have a lot of stuff. No AI, at least not that I installed anything myself, and other than the native plugins, I only have 3 that I installed, along with Components, which are probably 20 or less, but I don’t think those are that relevant?

Yep, it is a swapfile. IIRC a change was made earlier this year to create a swapfile if under 5GB RAM (I think it used to be 1 GB?).

Clearly enough, plenty of spare capacity, you are good to go :+1:

[image] merefield: Watch it using htop during a build. I might give this a go myself next time. Do you just open a separate terminal window and type htop? Any recommended options? I’ll do an internet search for more general information about it.

Should I increase the swap file from 2GB?

Product Support Self-hosting

NateDhaliwal (Nate Dhaliwal) December 21, 2025, 5:27am 4

I don’t believe a swap partition was mentioned?

I think 2GB swap + 4GB RAM is enough. I don’t think you’d need more swap unless you’re running other stuff on your server as well.

Topic		Replies	Views
Create swapfile in installation guide Self-hosting server-resources	7	1036	August 15, 2021
Error rebuilding on 2GB RAM without swap Self-hosting server-resources	8	728	October 3, 2023
Should we increase the default swap space to 3GB or 4GB? Self-hosting	12	1051	February 8, 2024
1GB ram Discourse setup / swap file error Product Support server-resources	6	1504	October 27, 2017
Discourse Swap Memory (1GB Warning) Product Support server-resources	7	3585	April 29, 2021

Should I increase the swap file from 2GB?

Related topics